Westinghouse WFE904SD User Manual page 6

INSTALLATION OF THE APPLIANCE (CONTINUED)
If your kitchen has a 900mm height kitchen bench
top, follow the quick measurement guide below before
putting the cooker upright
50mm
For a 900mm height kitchen bench top,
adjust the lower half of the feet to measure
50mm as shown in the illustration.
Tilt the appliance upright by lifting the back of the hob
and pivoting it about the back two feet.
WARNING WARNING
Heavy item! This step must be performed by two
persons.
10
INSTALLATION OF THE APPLIANCE
Leveling oven
Place a level in the oven as below making sure the
level sits on the front and rear forms. Adjust the feet
accordingly to level the appliance.
Installing splashback
Fit splashback to rear of hob with three screws provided.
Freestanding installation (continued)
Installation the anti-tilt brackets
To ensure cooker stability, the anti-tilt brackets must
be installed.
There are left and right engagement slots for the
anti-tilt bracket at the bottom rear of the appliance.
The following steps must be followed to ensure the
correct installation of anti-tilt brackets and the stability
of the appliances.
CAUTION WARNING
It is not recommended to push and pull the appliance
on uneven or rough surface. Use other means to
maneuver the appliance if necessary.
1. Carefully push the appliance into the cabinet cavity
until the back of the oven is flush against the back wall.
2. Use non-permanent methods to mark a line on the
wall along the top surface of the splashback. This line
is used as a reference line to locate the correct location
of where the anti-tilt brackets need to be installed.
3. After the reference line is marked, pull the appliance
out of the cabinet cavity to install the anti-tilt brackets.
Anti-tilt bracket
installation
reference line
INSTALLATION OF THE APPLIANCE
11