Wfe916Dsd - Westinghouse WFE904SD User Manual

CERAMIC COOKTOP MODELS
Freestanding cooker with electric ceramic hob and multi-function electric oven
Stainless steel splashback
Oven control panel
Oven door
Clip on kick panel included
Control Panel
Model WFE946SD
Oven function
selector
6
CERAMIC COOKTOP MODELS
Hob element controls
Ceramic glass hob (Refer
to Chapter'Get to know
your ceramic cooktop')
Storage compartment
Oven/Grill
temperature control
INSTALLATION OF THE APPLIANCE
Cabinet requirement
Models WFE904SD, WFE915SD, WFE916DSD,
WFEP917DSD & WFE946SD are designed to fit into a
900mm wide gap between standard kitchen cabinets.
The appliance integrates with the kitchen cabinets by
matching the height, depth and kick panel. The cooker
may also be installed at the end of a line of benches
or with a free space either side. In addition, a slot-in
type installation is catered for allowing a continuous
cabinetry kick panel to be used.
WARNING WARNING
• The cooker must be installed and serviced only
by an authorised person.
• A Certificate of Compliance MUST be supplied to
be kept by the customer.
• The packing materials must be removed before
you install the cooker.
• The surrounding kitchen cabinets must be able
to withstand 85°C. Electrolux WILL NOT accept
responsibility for damage caused by installation
into kitchen cabinets which cannot withstand 85°C.
• The pipes used for installation MUST have sufficient
loops so the cooker can be moved for service
(gas models).
• The vents, openings and air spaces MUST NOT
be blocked.
• Two anti-tilt brackets are supplied and stored in the
base of the packaging
• The anti-tilt brackets and chain or front stops
MUST be installed to avoid accidental tipping
(freestanding and slot-in models).
• You MUST NOT lift or pull the cooker by the
door handle.
• The cooker MUST be checked every five years.
• If the supply cord is damaged,it must be replaced
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
• The appliance must not be installed behind a
decorative door in order to avoid overheating.
• Due to the weight (95-100kg) and size of the
cooker, 2 persons are required to install it.
Gas model clearance requirements
• Ensure the appliance is installed in accordance with
clauses 6.2.5 and 6.10.1.1 of AS/NZS 5601.1 or clauses
6.9.1 and 6.9.5 of AS/NZS 5601.2 with regard to
clearances to combustible surfaces and materials,
and clearances to rangehoods and exhaust fans,
to ensure clearances of 200mm from burners to
vertical combustible surfaces observe the minimum
dimension of 100mm from each side of the cooker to
combustible surfaces.
• Clearances to combustible surfaces may be reduced
if combustible surfaces are protected in accordance
with clause 6.10.1.2 of AS/NZS 5601.1, or clause 6.9.2
of AS/NZS 5601.2.
• When setting the cooker height, ensure the top of
the cooker is at least 10mm higher than the level of
the benchtop.
Dimensions
600mm minimum
vertical clearance
from combustible
surfaces
Gas hob 910mm
(adjustable 910-930mm)
Ceramic hob 906mm
(adjustable 906-926mm)
15mm
(height of trivet above hob)
Splashback
The splashback is secured to the back of the cooker.
REMOVE the splashback before installing the feet.
INSTALLATION OF THE APPLIANCE
7