Installing Burners And Trivets; Getting To Know Your Cooktop - Westinghouse WFE904SD User Manual

INSTALLING BURNERS AND TRIVETS

Installing burners
The burner crown must be fitted correctly into the
burner cup or damage will occur during operation.
• To do this, ensure that the 2 ribs on either side of the
spark plug hole are positioned into the 2 slots on the
burner cup.
• The burner cap and burner crown must be clean and
located correctly for the burner to light.
NOTE: When the burner is correctly fitted it will sit level
on the hob.
Burner cap
Burner crown
Flame
safeguard
sensor
Burner cup
Ignition
spark plug
Injector
Installing trivets
• The rubber feet on the trivets locate into the
contours of the hob.
• Take care when placing the trivets as dropping
them may damage the hob or trivet.
• The wok trivet sits on top of the trivet above the
wok burner (WFE916DSD & WFEP917DSD only).
Wok trivet
(WFE916DSD &
WFEP917DSD only)
Wok burner
Burner crown
24
INSTALLING BURNERS AND TRIVETS
Trivet installation sequence
Install the middle trivet first by aligning the trivet with
the wok burner and gently placing the trivet on hob.
The middle trivet is designed to guide the location
of the side trivets. Gently place the side trivets in the
orientation shown.
2
1
Corner support Self-locating tabs
Corner support
Self-locating tabs
Flame safeguard
Models with flame safeguard require the knob to
continue to be depressed after flame is established for
approximately 5 seconds. If the flame goes out when
the knob is released, simply depress the knob again, this
time holding it down with slightly more force for the
same length of time.
WARNING
WARNING
• Keep hands clear of burners when lighting.
• If burner does not light within 5 seconds, turn
Trivets
knob to 'Off' position, allow gas to disperse, then
try lighting again.
• Burners MUST be operated between 'HIGH' and
'LOW' settings only.
ENVIRONMENTAL TIPS ENVIRONMENT
To conserve gas, place the pan centrally over the burner
and adjust the flame so that it does not go past the edge
of the cookware.
NOTE: In the absence of electrical power, carry out
the ignition directly to the burner with a hand held
ignition source.
Burner cap

GETTING TO KNOW YOUR COOKTOP

Model WFE904SD & WFE915SD
2
1. Low heat burner (5.1MJ/h)
Used for simmering with small cookware items.
2. Medium heat burner (9.0MJ/h)
Used for normal cooking and simmering with mid size
cookware items.
3. High heat burner (12.1MJ/h)
Used for fast heating with large size cookware items.
4. Intense heat wok burner (14.4MJ/h)
Used for very fast heating with woks and other large
size cookware items.
Model WFE916DSD & WFEP917DSD
1. Low heat burner (5.1MJ/h)
Used for simmering with small cookware items.
2. Medium heat burner (9.0MJ/h)
Used for normal cooking and simmering with mid size
cookware items.
3. High heat burner (12.1MJ/h)
Used for fast heating with large size cookware items.
4. Intense heat wok burner (19.0MJ/h)
Used for very fast heating with woks and other large
size cookware items. Use wok trivet provided when
cooking with a wok.
Using your gas hot plates
(All gas hob model)
2
1 4 3
To light a burner with this knob, firstly depress and
turn anti-clockwise to the 'High' flame position.
The knob maybe released once the flame is established
and turned further anti-clockwise to reduce the flame
height as desired.
Note 1: Gas control has limited movement.
Note 2: If the flame goes out when either knob is
released, simply depress the knob again, this time
holding it down for approximately 5 seconds.
Using your dual flame wok hot plates
(WFE916DSD & WFEP917DSD)
2
To light the wok burner, depress the knob and turn
anti-clockwise to ignite the inner and outer burners.
1 4 3
The knob may be released when both inside and outside
flames are established. Turning the knob further anti-
clockwise will reduce the height of the outer flame.
Turning the knob to 'Mid' and further will distinguish
the outer flame and control the height of the inner flame.
Turning the knob back to 'High' will reignite the
outer flame.
25
GETTING TO KNOW YOUR COOKTOP