Optional Mounting Guidelines; System Configuration (Example) - Knoll 400 User Manual

2.3 Optional mounting guidelines

NOTICE
When disconnecting components such as the power
supply, Bus cable or the handset, the strain relieve hook
must be pressed before removing the connector. When
inserting the connector, an audible "click" indicates that
the strain relieve hook has correctly re-engaged.
DANGER—Grounding
instruction
This product does NOT require grounding to
earth. This product is double insulated and equipped
with a polarized 120V plug and 2-conductor cord. The
plug must be plugged into an
appropriate building outlet that is
properly installed in accordance
with all local codes and
ordinances. Please read section
4.4 as well.
DANGER – Risk of
electrical shock
Improper connection of the equipment can result in a
risk of electric shock. Check with a qualified electrician
for any concerns. Do not modify the plug provided
with the product—if it will not fit the outlet have a
proper outlet installed by a qualified electrician.
This product is designed for the voltage indicated on
the power supply label. No adapters should be used
with this product.
©Knoll, Inc.
CAUTION—Risk of
electrical shock
Risk of electrical shock.
Before you plug in the power cord, check the following
again:
• The voltage must be as specified on the power
supply label.
• When the power cord is plugged in, the electrical
control devices are operational.
NOTICE
In case of a power failure or if the power cord is
unplugged during the movement of the drives, a manual
reset may be necessary! See section 3.2
2.4 System configuration
(example)
The figure below shows a configuration example
consisting of:
1 Power Supply
2 Bus cable
3 Handset
4 Control unit
Reff Profiles Height Adjustable Electric Stroke 400/420 User Manual 8