Port Management; Port Configuration - Planet FT-902S15 User Manual

4.3 Port Management

4.3.1 Port Configuration

This function allows displaying TP / Fiber port status. The Link Status in the screen displays the current connection speed
and duplex mode; else this function will show red
button to renew the screen. The screen in
Managed Media Converter.
The Port Configuration Web page includes the following configurable data:
Port
Link
Mode
Flow Control
when the TP / Fiber port is disconnected. Press the "Refresh"
"Down"
Figure 4-20 appears and
Figure 4-20 Port Configuration Web Page screen
Indicate the TP port and Fiber port.
Displays the current connection speed and duplex mode of TP or Fiber port.
Allow configuring the TP or Fiber port speed and operation mode. Draw the menu
bar to select the mode.
TP Port:
• Auto Speed - Setup Auto negotiation.
• 100 Full
- Force sets 100Mbps Full-Duplex mode.
• 100 Half
- Force sets 100Mbps Half-Duplex mode.
• 10 Full
- Force sets 10Mbps Full-Duplex mode.
• 10 half
- Force sets 10Mbps Half-Duplex mode.
Default mode: Auto Speed.
Fiber Port:
• 100 Full
- Force sets 100Mbps Full-Duplex mode.
Allow Disable or Enable Flow Control of TP or Fiber port.
• Enable – IEEE 802.3x Flow Control is enabled on Full-Duplex mode or
Backpressure is enabled on Half-Duplex mode
• Disable – No Flow Control or backpressure function on no matter
Full-Duplex or Half-Duplex mode
-26-
Table 4-6 describes the Port Configuration object of