Generac Power Systems R-200 Technical Manual page 5

Figure 1 — Dip Switch Settings
J5
ON
1
2
SOFTWARE P/N
3
REV # 4
5
DATE XXXX
6
7
8
RL1
J1
POS OFF
1
DIP SWITCH
2 ATS
3 LOW SPD
4 LP
5 2.4 - 35kW
6 6 CYL
7
8

If the DIP switch settings are not set correctly,
the generator engine may run rough, not start
or not provide rated power. When LP fuel
is used it is very important that DIP Switch
Position 4 be in the LP fuel position (switch
OFF).
J4
U9
U7
ON DESCRIPTION
RESERVED
GTS TRANSFER SWITCH MODE
NORMAL EXERCISE MODE
NG FUEL TYPE
2.4 - 45kW / 3.0L ENGINE TYPE / kW RATING
4 CYL # OF CYLINDERS
RESERVED
RESERVED
R-panel Technical Manual
LED Indicators visible through front panel (see Table
1 and Figure 2).
• System Ready
• Low Fuel Pressure
• Low Battery
• Low Oil Pressure
• Hi Coolant Temp/Low Coolant Level
• Over Speed/RPM Sensor Loss
• Over Crank
J2
Figure 2 — LED Indicators on Front Panel
J3
General Information
Table 1
Green LED
Yellow LED
Red LED
Red LED
Red LED
Red LED
Red LED
OVERCRANK
OVERSPEED
LOW COOLANT LEVEL
HI COOLANT TEMPERATURE
LOW OIL PRESSURE
LOW BATTERY
LOW FUEL PRESSURE
SYSTEM READY
3