Unitronics Samba SM70-J-TA22 Installation Manual page 11

Samba™ PLC+ HMI
Changing I/O Settings
The I/O board of the controller is now
exposed, enabling you to change
I/O settings (module dependent) according to
the jumpers setting above.
Note: Photo is for illustration purposes only.
(Using SM70)
Closing the Controller
Replace the back cover of the controller and fasten the corner screws.
Note that you must replace the back cover securely before powering up the controller.
FINLAND RUSSIA
info@klinkmann.fi klinkmann@klinkmann.ru
www.klinkmann.fi www.klinkmann.ru
ESTONIA LATVIA
info@klinkmann.ee info@klinkmann.lv
www.klinkmann.ee www.klinkmann.lv
BELARUS KAZAKHSTAN
minsk@klinkmann.com klinkmann@klinkmann.kz
www.klinkmann.by www.klinkmann.kz
LITHUANIA UKRAINE
info@klinkmann.lt klinkmann@klinkmann.kiev.ua
www.klinkmann.lt www.klinkmann.com.ua