Installation Instructions; Drill Holes; Install Latch; Install Strike - Kwikset PL1 User Manual

KEYPAD ELECTRONIC DEADBOLT

INSTALLATION INSTRUCTIONS

Backset is a distance from door edge to centre of hole
on door face.
Adjustable latch fits both BACKSET of 2-3/8" (60mm)
and 2-3/4" (70mm). Please follow the steps shown
below for BACKSET adjustment.
Latch Face Plate
Determine which latch mounting method will be used and
make necessary adjustments.
No adjustment required for square latch face plate.
Change latch face :
1. Use a flat screwdriver to separate the face plate.
2. Snap selected latch face onto back plate.
Dive in installation
Drive in faceplate installation Remove the
faceplate.
Align the round faceplate with the latch
bolt and push it inside the latch bolt
until you hear the catch click.
1. Mark The Door With Template
Select the height and backset as desired on the door face ;
use the TEMPLATE as an indication to mark the center of
the circle on the door face and the center of the door edge.

2. Drill Holes

Using the marks as a guide to drill a hole Ø2-1/8" (54mm)
through the door face for the lockset, then a hole of Ø1"
(25.4mm) for latch.

3. Install Latch

a
b
c
d
Drive-In Latch
2-3/4 (70mm)

4. Install Strike

a
a. To identify the center of strike : close the door, based on the faceplate mark
horizontal center line of strike.
Ensure the center of faceplate and the center of strike are aligned.
Use the mark as a guide outlines the strike.
b. Chisel 5/64" (2mm) deep along the strike outline to allow the strike to be aligned
with the doorframe.
c. Insert the strike and tighten it with screws.
Note : please use "tapping screws" for a metal door.
1
a. Insert the latch and ensure it is parallel to the door face.
Mark the outline of the faceplate, then take out the latch.
b. Chisel 5/32" (4mm) deep along the outline to allow the
faceplate to be aligned with the door edge.
c. Insert the latch and tighten it with screws.
Note : please use tapping screws for a metal door.
d. For drive in application, drive the latch into the hole on
edge of door and go to step 4.
c
b
2