Install Keypad Assembly; Install Inside Mounting Plate; Identify Door Handing; Adjusting Turn Piece - Kwikset PL1 User Manual

5. Install Keypad Assembly

a. Make sure the latch bolt is retracted.
b. Please refer to the diagram below for Cylinder Installation.
Place deadbolt against keypad with tailpiece in horizontal
position inserted through hub of the latch.
c. Pass the IC wire under the latch to the interior side of the door.
a
b
Cylinder

6. Install Inside Mounting Plate

Pass the IC wire through the wire hole of
the mounting plate.
Fix the mounting plate with screws.
Screws
If outside lock assembly is lopsided, please
loosen the screws to adjust it's position and
tighten the screws again.

7. Identify Door Handing

Face the door from outside, the door is left handed if the hinge is on the
left-hand side of the door, whereas the door is right handed if the hinge
is on the right-hand side of the door.
Interior
Door
Exterior
(Left Handed) (Right Handed)

8. Adjusting Turn Piece

Turn the turn piece to left for 45 degrees
for a right-handed door.
Turn the turn piece to right for 45 degrees
for a left handed door.
c
9. Install receiver module
IC wire
a. Remove the battery cover
(push it up and pull it out).
b. Connect the IC wire and ensure the tailpiece
is engaged with turn piece, then attach
receiver module to the door with screws.
Use wood screws for a wooden door.
Mounting Plate
c. Insert 4 (AA) 1.5V alkaline batteries and
put the battery cover back to the receiver
module.
IC wire
b
Hinge
3
(For Right Handed door)
a


c
Wood Screws
Screws
Turn Piece
(For Left Handed door)
Battery
Cover
4