Setting Up Documents; Placing A Document On The Platen Glass - Canon imageCLASS D661 Reference Manual

Setting Up Documents

For scanning, place your documents on the platen glass or load them into the ADF. Where you set up your
documents depends on the size and type of documents you have. (→ p. 3-1)

Placing a Document on the Platen Glass

1
Open the ADF.
2
Place your document face down on the
platen glass. Align the document with the
appropriate paper size marks.
Positioning Documents
Use the size indicators on the left side of the platen glass to position a document.
I If your document conforms to a standard paper size (e.g., LTR or STMT), align the document between the
appropriate paper size marks.
I If you do not know the size of your document, or if your document does not match any of the paper size
marks, align the center of your document with the ➔ mark.
The illustration below shows how to place an LTR-size original.
LTR/
FLS/
LGL
STMT
STMT
LTR/
FLS/
LGL
A4
B5
A5
A5
B5
A4
3
Gently lower the ADF.
• The document is now ready for scanning.
3
3-3