Cavaliere CAV-SV168M-30 Quick Start Manual
  1. Manuals
  2. Brands
  3. Cavaliere Manuals
  4. Ventilation Hood
  5. CAV-SV168M-30
  6. Quick start manual

Cavaliere CAV-SV168M-30 Quick Start Manual

Hide thumbs
1
2
3
4
5
6

Advertisement

Table of Contents

Tools Needed
Marker or Pencil
Utility Knife
Measuring Tape
Level
Flat & Phillips
Powered Drill
Screwdrivers
■r. n � - � ,• - ----------------
-----------------J

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CAV-SV168M-30 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Cavaliere CAV-SV168M-30

Summary of Contents for Cavaliere CAV-SV168M-30

  • Page 1 Tools Needed Marker or Pencil Utility Knife Measuring Tape Level Flat & Phillips Powered Drill Screwdrivers ■r. n � - � ,• - ---------------- -----------------J...

  • Page 2: Venting Requirements

    Venting Requirements Height & Clearance n.;;:;;;:;;;:i:...- upper Maximum* ceiling • Vent system must terminate to the outside clearance 102" at 29" Chimney (roof or side wall). hood mounting height Mounting above countertop/stove • DO NOT terminate the vent system in an (may vary with different Bracket attic or other enclosed area.

  • Page 3: Venting Methods

    Venting Methods • This range hood is factory set for venting through the roof or wall. ° • Vent work can terminate either through the roof or wall. To vent through a wall, a 90 elbow is needed. IMPORTANT: • NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or garages.

  • Page 4: Height & Clearance

    Height & Clearance IMPORTANT: • A minimum of 6" round (standard for this range hood) must be used to maintain maximum airflow efficiency. • A flexible 6" round duct is provided for convenience and for use in difficult installations, however always attempt to use a smooth metal/aluminum rigid type of ducting to maximize airflow efficiency.

  • Page 5: Charcoal Filter Installation

    Charcoal Filter Installation NOTE: OPTIONAL CHARCOAL FILTERS (SOLD SEPERATELY) 1. Remove grease filters from the hood. 2. Position the charcoal filters onto both side of the motor housing, aligning the mounting points, turn until it locks. Re-install ba ffle filters. 3.
  • Page 6 Preparation Advanced Preparations: & WARNING 1. Familiarize yourself with the controls of the range hood by reading through Range Hood Operations, Page 15. Excessive Weight 2. Place the range hood on a flat, stable surface. Connect the Require three or more persons to range hood to a designated standard outlet (please refer move and install this range hood.

Table of Contents