Advertisement
Available languages
Available languages
Principio
2/11/04
All manuals and user guides at all-guides.com
water, rinse and then dry. Clean the inside of the coffee maker by
brewing two full jugs of tap water (see brewing instructions).
Do not place coffee in the filter holder for this initial cleaning.
Note: At the end of the first cycle turn the coffee maker off and wait
ten minutes. Turn the unit on and brew a second jug of water.
Replace the disassembled parts.
SPECIAL CARE FOR YOUR JUG
Note : Any glassware is not covered by the guarantee.
A damaged jug may result in possible burns from hot liquid. To
avoid breaking the jug:
1 Do now allow all the liquid to evaporate from the jug. Do not heat the
jug when empty.
2 Discard the jug if damaged in any manner. A chip or crack could
result in breakage or contaminate liquid contents with glass
particles.
3 Never use abrasive scouring pads or cleansers as they may
scratch and weaken the glass.
4 Do not place the jug on or near a hot gas or electric burner, in a
heated oven, or in a microwave oven.
5 Avoid rough handling and sharp blows.
BREWING INSTRUCTIONS (Illustrations 1 to 4)
1 Place the coffee maker on a flat, stable, heat resistant surface.
2 Plug the coffee maker into an electrical socket, which meets the
voltage indicated on the appliance.
3 Fill the jug with fresh, cold tap water. Markings on the tank indicate
the level of water required for brewing the desired number of cups.
4 Place a coffee filter paper in the filter holder. Measure one level
tablespoon of regular grind coffee for each cup of coffee desired.
For stronger or milder coffee, adjust the amount of coffee to suit your
taste.
5 Return the filter holder to its base and close the lid.
6 Place the jug on the warming plate.
7 Switch the control button to on. The on light will indicate the unit is
in operation.
8 If your wish to serve a cup of coffee before the end of the brewing
cycle simply remove the jug from the warming plate. Dripping will
automatically cease. Return the jug to its position on the warming
plate within 45 seconds and brewing will resume.
9 Upon completion of the brewing cycle, wait approx one minute
before using to allow any last traces of water remaining in the water
tank to filter through. The jug lid should be kept in place to facilitate
safe serving and help keep the coffee at a proper serving
temperature.
10 To keep the coffee hot, return the jug to the warming plate after
serving. The warming plate will automatically maintain the ideal
serving temperature providing the coffee maker is switched on.
11 Switch the control button to off when the jug is empty or when the
unit is not in use.
12 To brew another jug of coffee, turn the unit off and wait 10 minutes
to allow the heating element to cool.
Important : if the unit is not allowed to cool sufficiently before
repeated use, water placed in the water tank may become overheated
and a spray of steam could be released from the opening, creating a
risk of burns.
BREWING A SECOND POT OF COFFEE
As mentioned above, it is recommended that the coffee maker
should be switched off for 10 minutes between cycles in order to
allow the unit to cool. While the unit is in the off position, dispose of
used coffee and rinse the jug and filter holder in water. Place a fresh
filter paper in the holder then repeat brewing procedure.
16:27
Page 8
Advertisement
