Advertisement
Technical specifications
Nominal voltage (V)
Nominal frequency (㎐)
Nominal power P40 (W)
Idling speed (
⁄
)
r
min
Max. diameter of branches (㎜)
Capacity of collecting container (ℓ)
Sound pressure level (dB (A))
Sound power level (dB (A))
Weight (㎏)
Operating time P40 (s)
Protection class
Protection type
Troubleshooting
Problem
The engine is not run-
ning.
The
material
is
not
drawn in.
Material is not cut.
Warning!
In the event of an accident or any type of malfunction, first stop the appliance and
disconnect it from the mains. Always make sure that the moving parts are completely stationary.
Only then check the unit or call the customer service.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
230–240
50
2500
4050
40
50
95.7 (K=3)
guaranteed 111
measured
108.3 (K=2,64)
14
Full load: 40; idling: 60
II
I PX4
Cause
Safety interlock
Power outage
Material accumulates in-
side hopper
Shredder material too soft Insert wood and dried branches.
Cutting blade blocked
Motor protection triggered Remove all chaff pieces and press reset switch.
Materials jamming
Engine does not start.
Filling device clogged
Item 61075
Solution
Tighten screw plug well.
Check power cord, plug, and fuse in your home.
Switch off chopper, pull material out of hopper (first
disconnect it from mains!), connect power and
switch on shredder again and insert thick branches
so that knives do not interfere with previous inci-
sions again.
Unscrew hand screw, open shredder, and remove
material which does not block unit (disconnect unit
from power supply!).
Remove all chaff pieces from knives.
Check that power cord, connector, fuse and latch
are in proper condition.
Pull branches out of filling suction opening; alterna-
tively, use a rod to push or loosen branches inside
machine.
Page 13
10
2021-1
Advertisement
