Advertisement
starts to clog, IMMEDIATELY disconnect it from the power supply. Before removing the block-
age, the shredder MUST be disconnected from the power supply.
•
Keep the power unit free of waste and other debris to prevent damage or possible fire. Always
remember that the cutting tools continue to move for a while even after the machine has been
switched off. Always wait until the machine has come to a complete standstill.
•
Do not change in any way the motor controller settings! The controller controls the safe maxi-
mum operating speed and protects the engine and all moving parts from damage caused by
excessive speed. Always switch off the shredder as soon as you leave the working area. Always
consult a specialist operator or customer service if you have a problem.
•
Never tip the machine when the engine is switched on. Never operate it with defective guards
or without safety devices such as the attached collecting tank. If the cables are damaged, stop
operation!
•
Warning!
resistance) of the device is 0.333 Ohm. As the user of this device, you must consult the
power supply company in case of doubt. The device may only be connected to a power
supply whose impedance is less than or equal to Z
Maintenance and storage
•
If the machine is switched off for maintenance, inspection, storage, or replacement of an acces-
sory (power unit MUST be disconnected in such cases), make sure that all moving parts are
stationary and any keys have been removed. Allow the machine to cool down before any in-
spection, adjustment, storage, etc.
•
Maintain the machine with care and keep it clean at all times. When maintaining the chaff unit,
be aware that, although the energy source is switched off due to the interlocking function of the
protective device, the chaff unit can still be moved. NEVER try to bypass the interlocking func-
tion of the guard!
•
When servicing the cutting tools, make sure that (even if the power source cannot be switched
on due to the safety lock) the cutting tools can still be switched on by a manual start mechanism.
Additional safety instruction for devices with collecting containers
The chopper must always be switched off before attaching or removing the collecting container!
Residual risk
•
Even when used as intended, residual risks may still exist despite compliance with all relevant
safety regulations due to the design determined by the intended use.
•
Residual risks can be minimised if the safety instructions and the intended use as well as the
operating instructions as a whole are observed. Consideration and caution reduce the risk of
injury or damage to property:
◦ risk of injury to fingers and hands if you reach with your hand through an opening and reach
the knife mechanism;
◦ risk of injury to fingers and hands during assembly and cleaning work on the knife mecha-
nism;
◦ injury due to chaff being thrown away in the area of the funnel;
◦ danger from electricity if incorrect electrical connection cables are used;
◦ contact with live parts when electrical components are open.
•
In addition, prolonged work without hearing protection may result in hearing loss or damage.
Despite all precautions taken, there may be non-obvious residual risks.
Extension cable
Only use extension cables approved for outdoor use (H05VV-F). The cable cross section must be equal
to or greater than 1.5 mm² for a length of up to 75 m. Extension cables longer than 30 m generally
reduce the performance of the machine.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
The maximum permissible mains impedance Z
Item 61075
(total alternate current
max
!
max
Page 8
10
2021-1
Advertisement
