Advertisement
Collecting container
•
Pull the safety handle at the upper end of the base frame and slide the collection container
under the base frame.
•
The collection container locks automatically when you release the safety handle.
•
To remove the container again, press the safety handle up and pull the container out of the base
frame.
Operation
On/off Switch
The machine can be started and stopped by pressing the on/off switch.
NOTE: The unit is equipped with a safety switch to prevent accidental restart after a power
failure.
Overload protection
•
Overload (e.g., due to blocking of the cutting blades) causes the machine to stop after a few
seconds. To prevent damage to the motor, the overload switch automatically switches off the
mains connection.
•
Wait at least 1 min before restarting the machine by pressing the reset button. If the motor still
does not start, do the following:
1. Disconnect the plug from the socket.
2. Loosen the screw plug and then open the upper part upwards.
3. Carefully clean the cutting and exhaust elements and remove any objects that may obstruct
cutting.
4. Replace the top and tighten the hand screw firmly.
5. Press the reset button again before pressing the on/off switch.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61075
Page 10
10
2021-1
Advertisement
