Advertisement
WARNING NOTES:
•
Always wear protective gloves while performing the above steps!
•
Never loosen the hand screw until you have switched off the machine via the on/off
switch and the plug has been removed from the socket!
Disassembly
Under certain circumstances, e.g., for storage after use, the machine can be disassembled by carrying
out the assembly steps in reverse order to the sequence described above.
Use
•
Place the material to be shredded into the filling opening on the right side. The branches are
then automatically fed into the machine by the counter-clockwise rotating cutter blade. Do not
put too much material into the opening at once to prevent the machine from blocking.
•
If garden waste that has already become slightly damp and rotten is to be disposed of, swap
between garden waste and branch plant during filling to avoid blocking the cutting blade. Com-
post soft kitchen waste, but DO NOT put it into the shredder.
•
Branches with leaves must have passed completely through the shredder before new material
can be added. Make sure that the shredded material can fall freely into the collecting basket
without blocking the outlet. The ventilation slots must not be blocked by the chopped (cov-
ered/clogged/soiled) material.
•
Longer chipping of thick wood or strong branches can cause the machine to stop due to clogging
or jamming. Soft material such as leaves or small twigs can easily clog the feeder. Use a stick
to push in this material.
•
Waste material must always be inspected for nails, stones, and other solids beforehand, as
such objects can seriously damage the shredder.
•
Beware of vibrations, as these are usually a typical sign of worn or damaged cutting blades.
Always replace the cutting blades if necessary.
Care and maintenance
WARNINGS!
•
Make sure that the garden shredder is switched off and disconnected from the mains
before carrying out any cleaning or maintenance work on the machine. Always wear
sturdy protective gloves when cleaning the cutting blades!
•
Risk of injury from moving and dangerous parts!
•
To maintain the efficiency of the shredder, it must be kept clean. Clean the shredder after each
use!
•
Do not allow shredded material to dry or harden on the surfaces of the shredder. This has an
immediate negative effect on the shredding performance.
•
Always ensure a clean filling and ejection chute free of waste material.
•
Always make sure that all nuts, bolts, and screws are tight!
•
Always have defective and worn parts repaired or replaced by a qualified person.
•
Do not use cleaning agents or solvents, as they may cause irreparable damage to your machine.
Chemicals can destroy plastic parts.
•
After every fourth or fifth use, the knives must be oiled!
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 61075
Page 11
10
2021-1
Advertisement
