Marking The Template And Drilling The Door; Installing The Latch - Kaba SIMPLEX LD470 Installation Instructions Manual

A-11 Using the hex wrench supplied, remove the set screw from the lever in
question.
A-12 Remove the lever and rotate it 180º. Slide the lever back onto the lock.
A-13 Using the hex wrench supplied, reinstall the set screw. Assure the lever
rotates freely.
A-14 Reinstall the rubber plug, which was removed earlier.
B. MARKING THE TEMPLATE AND DRILLING THE DOOR
B-1 Find and remove the template from the installation manual. Carefully fold
along the dotted line that matches the backset the application requires.
B-2 From the exterior (or push button side) of the
door, place the dotted line of the template
along the edge of the door.
B-3 Carefully mark the 3 holes on the template
(2 mounting holes and 1 spindle hole.
B-4 Drill the 3 holes, making sure to drill
them straight.
C. INSTALLING THE LATCH
C-1 Using the center line of the latch (marked on template), mark the point
where the cross bore for the latch should be drilled.
C-2 Drill a 1" (25 mm) diameter hole, 3
of the edge of the door.
C-3 Insert the latch into the hole and outline the face of the latch (already
prepped on most metal doors).
C-4 Remove the latch.
C-5 Using a chisel, remove the material
the faceplate of the latch (already prepped on most metal doors).
C-6 Reinsert the latch and install the latch using the mounting screws provided.
⁄ " (96mm) deep, on that center point
3
4
⁄ " (3 mm) deep from the door for
1
8
5