Procedure 6.4 - Replacing Drive Motor - Precor 9.33 Manual
Hide thumbs
Also See for 9.33:
- Owner's manual (52 pages) ,
- Product specification (1 page) ,
- Manuel de l'utilisateur (60 pages)
Table of Contents
Advertisement
Procedure 6.4 - Replacing Drive Motor
1.
Set the treadmill's on/off switch in the "off" position and unplug the treadmill's line cord from
the AC outlet.
1.
Remove the hood.
2.
Disconnect the drive motor connector from the OUTPUT connector on the power control
module.
3.
Remove the four bolts that fasten the drive motor to the frame. Remove the drive belt from
the drive motor.
4.
Set the replacement drive motor in its mounting position. Place the drive belt on the drive
roller pulley and on the drive motor pulley.
5.
Adjust the drive belt tension and complete the motor installation per Procedure 4.2.
6.
Thoroughly check the treadmill per Section 3.
9.33, 9.35 240V Treadmill
Page 37
- Quick Links:
- Procedure 4.3 - Treadmill Belt Cleaning
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
