Precor 9.33 Manual page 7

Procedure 2.2
The information display will access the following data;
• Odometer
• U Boot SW
• U Base SW
• Lower SW
• Usage log
• Error log
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. Refer to diagram 2.1 above and press keys RESET,6,5 sequentially. Use the numeric
keypad to enter the number sequence. The ARROW keys will step you through the display
modes listed above, allowing you to skip displays or view only specific displays.
3. The display will momentarily read, DIAGS - INFORMATION DISPLAY.
4. ODOMETER
5. Press the OK or ENTER key. The treadmill's odometer will be displayed as 1234567 MILES
or 1234567 KM.
Note: The odometer data is stored in non-volatile memory on the upper PCA. If the upper PCA
is replaced the odometer data will be lost.
6. Press the OK or ENTER key to exit the odometer display.
7. HOUR METER.
8. Press the OK or ENTER key. The operating time of the unit will be displayed as 12345
HOURS. The operating time is defined as total amount of time that the unit has operated in
program modes with the drive motor running. The hour meter is also used to provide the
"time stamp" for the error code log.
9. Press the OK or ENTER key to exit the hour meter display.
10. U BOOT SW
11. Press the OK or ENTER key. The U Boot SW part number will be displayed. The U Boot SW
is the software internally used to upload upper PCA operating system software (U Base
SW).
12. Press the OK or ENTER key to exit the U Boot SW display
- Accessing the Information Display Program
9.33, 9.35 240V Treadmill
Page 7