13. If you have performed all of the procedures above and have been unable to correct the
problem, call Precor customer service.
14. Set the treadmill's on/off switch in the "off" position. Remove the incline motor's connector
from the INCLINE connector on the power control module. Visually inspect the incline
motor's wiring and connector for any broken or improperly crimped connections. With an
ohmmeter, read between terminals 3 & 4, 4 & 8 and 3 & 8 of the INCLINE connector.
Terminals 3 & 4 should read approximately 1KΩ. The sum of the readings between
terminals 4 & 8 and 3 & 8 should total approximately 1KΩ. If either reading is significantly
high or open, replace the incline motor.
15. If you have performed all of the procedures above and have been unable to correct the
problem, call Precor customer service.
9.33, 9.35 240V Treadmill
Page 23