Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Alarm.Com ADC-V724
Summary of Contents for Alarm.Com ADC-V724
- Page 1 1080p Outdoor Wi-Fi Camera with Two-Way Audio Installation Guide ADC-V724...
-
Page 2: Pre-Installation Checklist
Pre-installation checklist • ADC-V724 camera (included) • AC power adapter (included) • Wi-Fi (2.4 or 5 GHz) connection to broadband Internet (Cable, DSL, or Fiber Optic) Internet • A computer, tablet, or smartphone with Wi-Fi is required if the router does not have the Wi-Fi Protected Setup (WPS) feature. - Page 3 In the box Overview ❶ ❹ Status LED Speaker ❷ ❺ SD Card Door Microphone ❸ ❻ SD Card Slot WPS/Reset button ❶ ❺ ❻ ❸ ❷ ADC-V724 camera Power adapter ❹ Installation Guide Wall anchors & screws (x3)
-
Page 4: Rubber Plug
Rubber Plug A rubber plug has been included with your ADC-V724 at the base of the mount. This rubber plug should only be used if you are mounting directly over a hole in the wall. The rubber plug will provide a seal to prevent water from entering the hole in the wall behind the camera. -
Page 5: Installation
URL field. Follow the on-screen instructions Add the device to the account by either selecting the account in to add the ADC-V724 to the Wi-Fi network. The LED will briefly MobileTech or by using a web browser and entering the following turn red before blinking green. -
Page 6: Troubleshooting
(about 15 seconds), then release the button. The camera will reboot to factory default. If the camera was previously installed to an Alarm.com account, Blinking green - Local network connection it will need to be deleted before it can be installed again. - Page 7 Notices ISED statement This device contains licence-exempt transmitters(s)/receiver(s) that comply with Federal Communication Commission Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). interference statement Operation is subject to the following two conditions: This equipment has been tested and found to comply with the limits for a This device may not cause interference.
- Page 8 Le présent émetteur radio [IC: 4491A-V723] a été approuvé par Innovation, Sciences et IMPORTANT NOTE: Développement économique Canada pour fonctionner avec les types d’antenne énumérés IC Radiation Exposure Statement: ci dessous et ayant un gain admissible maximal. Les types d’antenne non inclus dans cette This equipment complies with IC RSS-102 radiation exposure limits set forth for an liste, et dont le gain est supérieur au gain maximal indiqué...
- Page 9 8281 Greensboro Drive Suite 100 © 2021 Alarm.com. All rights reserved. Tysons, VA 22102 210303 | Made in China.
Need help?
Do you have a question about the ADC-V724 and is the answer not in the manual?
Questions and answers
A picture showing SD Card installation
To install the SD card in the Alarm.com ADC-V724 camera:
1. Use a recommended surveillance-grade micro SD card.
2. Make sure the SD card is brand new.
3. Insert the SD card into the camera within 12 hours of camera installation to initiate the Onboard Recording process.
4. If the recording schedule is not created automatically, manually create the schedule.
To verify proper insertion, check SD card info using the Alarm.com app or website.
This answer is automatically generated