Broadband (Cable, DSL, or Fiber Optic) Internet connection with router • A computer or mobile device with Internet access • An Ethernet / Cat5 cable • Login and Password for the Alarm.com account to which you will add the camera ADC-V821 Installation Guide...
Wait 2 minutes for the camera to connect to the Internet. Add the device by either selecting the account in MobileTech OR by using a web browser and entering the following URL: www.alarm.com/addcamera ADC-V821 Installation Guide ADC-V821 Installation Guide...
Unscrew and remove the camera cover, being careful to not damage the connecting wires. Reset Button Gimbal Press and hold the Reset button for 6 seconds or until Bottom Case the IR LEDs flash red. DC Power Cable RJ-45 Cable ADC-V821 Installation Guide ADC-V821 Installation Guide...
Connect the Ethernet cable to the camera by feeding the cable through the appropriate hole. If required, connect the power cable. If you are installing on a hard ceiling or wall, skip to Step 8. ❻ ❹ Ethernet Ethernet Cable Cable Power ADC-V821 Installation Guide ADC-V821 Installation Guide...
Page 6
❾ If the light sensor is shielded by the cover, the camera will always be in night mode. Remove the protective film from the dome cover. 70° Max ADC-V821 Installation Guide ADC-V821 Installation Guide...
Page 7
3. The correct disposal of your old appliance will help prevent potential negative consequences for the environment and human health. 4. For more detailed information about disposal of your old appliance, please contact your city office, waste disposal service or the shop where you purchased the product. ADC-V821 Installation Guide ADC-V821 Installation Guide...
Need help?
Do you have a question about the ADC-V821 and is the answer not in the manual?
Questions and answers