Go to
https://support.lenovo.com/partslookup
part:
SSD mylar
Remove the DC-in bracket
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 30
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Remove one screw and then remove the DC-in bracket.
Figure 12. Remove one screw and then remove the DC-in bracket
Screw specifications
M2 x L3.5
Go to
https://support.lenovo.com/partslookup
part:
DC-in bracket
Remove the memory module mylar
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 30
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Peel off the memory module mylar.
to look up the Lenovo part number of the following replacement
Number of screws
1
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
35