Remove The Dc-In Bracket; Remove The Memory Shielding And Memory Modules - Lenovo Legion Slim 5 Hardware Maintenance Manual

Remove the DC-in bracket

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 29
Step 1. Disconnect the battery pack cable from the system board. Remove one screw and then remove the
DC-in bracket.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Figure 7. Remove the DC-in bracket
Screw specifications
M2 × L3
Go to
https://support.lenovo.com/partslookup
replacement part:
DC-in bracket

Remove the memory shielding and memory modules

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 29
Step 1. Disconnect the battery pack cable from the system board. Peel off the tape. Then, remove the
memory shielding.
Attention: Use your fingernail to pull the connector to unplug it. Do not pull the cable.
Number of screws
1
to look up the Lenovo part numbers of the following
Torque
1.85 ± 0.15 kgf-cm
.
Chapter 4 Removing a FRU or CRU
31