Table of Contents
Advertisement
Remove the DC-in bracket
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 30
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Remove two screws and then remove the DC-in bracket.
Figure 18. Remove two screws and then remove the DC-in bracket
Screw specifications
M2 x L6.0
Go to
https://support.lenovo.com/partslookup
part:
DC-in bracket
Remove the thermal module
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the solid-state drive (SSD) plate (L)" on page 31
"Remove the solid-state drive (SSD) plate (R)" on page 32
Step 1.
Detach the thermal module cable connectors and then remove four screws.
Number of screws
2
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
39
Advertisement
Table of Contents
