Remove the DC-in bracket
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the thermal module" on page 35
Step 1.
Remove one screw. Then, remove the DC-in bracket.
Figure 15. Remove one screw. Then, remove the DC-in bracket.
Screw specifications
M2 × L3
Go to
https://support.lenovo.com/partslookup
replacement parts:
DC-in bracket
Remove the I/O board
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 30
"Remove the thermal module" on page 35
Step 1.
Disconnect the I/O board cable and coin-cell battery cable.
Number of screws
1
to look up the Lenovo part numbers of the following
Torque
1.85 ± 0.15 kgf-cm
.
Chapter 4
Removing a FRU or CRU
37