Sony STR-DA5200ES Operating Instructions Manual page 70

8
Press V/v repeatedly to select
the position number, then press
or b.
You can rename the position number,
refer to "Naming inputs" (page 92).
9
Press V/v repeatedly to select
"Manual Setup," then press
or b.
10
Press OPTIONS, then select
"Speaker Pattern".
Select "Speaker Pattern" according to the
speaker system which you are using. You
do not need to select the speaker pattern
after auto calibration.
11
Press V/v repeatedly to select
the speaker pattern you want.
12
Press OPTIONS.
70
GB
13
Press V/v repeatedly to select
"Test Tone," then press
The test tone is output from each speaker
in sequence.
You can select the test tone type. For
details, see "Option menu parameters of
Auto Calibration settings" (page 73).
14
Select the speaker you want to
adjust, then adjust the
parameter using V/v.
Tips
• To adjust the level of all speakers at the same
time, press MASTER VOL +/–.
• The adjusted value is shown on the display
during adjustment.
15
Press V/v repeatedly to select
"OFF," and then press
The test tone turns off.
When a test tone is not output
from the speakers
• The speaker cords may not be connected
securely. Check to see if they are connected
securely and cannot be disconnected by
pulling on them slightly.
• The speaker cords may have the short-circuit
problem.
When a test tone is output from
a different speaker than the
speaker displayed on the
screen
The speaker pattern to the connected speaker
is not set up correctly. Make sure the speaker
connection and the speaker pattern match.
For more precise adjustment
You can output the test tone or sound source
from two adjacent speakers to adjust their
balance and level.
Then select the two speakers you want to
adjust using "Phase Audio" or "Phase Noise"
in the Auto Calibration settings menu
(page 73).
.
.