Sony STR-DA5200ES Operating Instructions Manual page 45

Note
You cannot measure the speaker height of the
surround speakers and the surround back speakers.
Set this value from the surround position settings in
the Auto Calibration settings menu (page 72).
Tips
• Operations other than turning the receiver on or off
are deactivated during auto calibration.
• In the following situations, the measurements have
not been performed correctly or auto calibration
cannot be performed.
– when connecting special speakers, such as
dipole speakers.
– when using the zone 2/zone 3 function in zone 2/
zone 3.
To cancel the auto calibration
Auto calibration is cancelled when you change
the volume, switch functions, change the
speaker setting of the receiver, or connect
headphones.
Confirming/saving the
measurement results
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the TV screen.
Note
When the speaker(s) is (are) out of the phase,
"Out Phase" is displayed on the TV screen.
The "+" and "–" terminals of the speaker may
be connected the other way around. However,
depending on the speakers, "OUT-OF-
PHASE" appears on the TV screen even
though the speakers are connected properly.
This is because of the speakers' specifications.
In this case, you can continue to use the
receiver.
Tip
The displayed unit of distance for models for
US and Canada is feet. The unit of distance for
models for countries/areas other than US and
Canada is meters. You can change the unit of
distance use in "Distance Unit" in the Auto
Calibration settings menu.
2
Press to select "Next."
When "Auto calibration (auto speaker
setup) complete but an issue occurred.
Confirm Issue?" appears on the TV
screen, you can select whether to confirm
the warning ("Yes") or not ("No").
Follow the instructions of the TV screen
when you select "Yes."
For details on warning and error codes,
see "Message list after auto calibration
measurement" (page 46).
Tip
Press on the remote when "Please Press
ENTER" appears on the TV screen.
3
Press B/b repeatedly to select
"Yes," then press
4
Press V/v repeatedly to select
"Auto EQ" mode, then press
.
The measurement results are saved.
.
continued
45 GB