6: Preparing The Receiver And The Remote - Sony STR-DA5200ES Operating Instructions Manual

6: Preparing the receiver
and the remote
Connecting the AC power cord
(mains lead)
Connect the supplied AC power cord (mains
lead) to the AC IN terminal on the receiver,
then connect the AC power cord (mains lead)
to a wall outlet.
AC OUTLET*
* The configuration, shape, number of AC outlets,
and the information described on the label will
vary according to the area.
**
** A several space is left between the plug and the
rear panel even when the power cord (mains
lead) is inserted firmly. The cord is supposed be
connected this way. This is not malfunction.
36
GB
AC IN terminal
To the wall outlet
AC power cord
(mains lead)
(supplied)
Notes
• The AC OUTLET(s) on the rear of the receiver is a
switched outlet, which supplies power to the
connected component only while the receiver is
turned on.
• Make sure that the total power consumption of the
component(s) connected to the receiver's AC
OUTLET(s) does not exceed the wattage stated on
the rear panel. Do not connect high-wattage
electrical home appliances such as electric irons,
fans, or TVs to this outlet. This may cause a
malfunction.
Performing initial setup
operations
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
1,2 2,3
1
Press POWER to turn off the
receiver.
2
Hold down POWER while
pressing TONE MODE and
MULTI CH IN to turn on the
receiver.
3
Release the TONE MODE and
MULTI CH IN after a few
seconds.
After "MEMORY CLEARING..."
appears on the display for a while,
"MEMORY CLEARED!" appears.
The following items are reset to their
factory settings.
2,3