Specifications - Sony STR-DA5200ES Operating Instructions Manual

• Make sure you select the correct input on
the remote.
• When you operate a programmed non-
Sony component, the remote may not
function properly depending on the model
and the maker of the component.
Error messages
If there is a malfunction, the display shows a
code of two numbers and a message. You can
check the condition of the system by the
message. Refer to the following table to solve
the problem. If any problem persists, consult
your nearest Sony dealer.
PROTECTOR
Irregular current is output from the speakers
or the USB device, or the upper panel of the
receiver is covered with something. The
receiver will automatically turn off after a
few seconds. Check the speakers or the USB
device connection and turn on the power
again.
Reference sections for clearing
the memory
To clear
All memorized settings

Specifications

AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 120 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
POWER OUTPUT
Rated Power Output at Stereo Mode
Reference Power Output at Stereo Mode
Reference Power Output
See
page 36
Reference Power Output
1)
Depending on the sound field settings and the
source, there may be no sound output.
2)
Measured under the following conditions:
Power requirements: 120 V AC, 60 Hz
1) 2)
(8 ohms 20 Hz – 20 kHz,
THD 0.09%):
120 W + 120 W
(4 ohms 20 Hz – 20 kHz,
THD 0.15%):
120 W + 120 W
(8 ohms 1 kHz, THD 0.7%)
2)
FRONT :
130 W + 130 W
2)
CENTER : 130 W
2)
SURROUND :
130 W + 130 W
2)
SURROUND BACK :
130 W + 130 W
(4 ohms 1 kHz, THD 0.7%)
2)
FRONT :
130 W + 130 W
2)
CENTER : 130 W
2)
SURROUND :
130 W + 130 W
2)
SURROUND BACK :
130 W + 130 W
continued
133 GB