Performing Auto Calibration - Sony STR-DA5200ES Operating Instructions Manual

Note
Depending on the characteristics of the sub woofer
you are using, the setup distance value may be
further away from the actual position.
Using the receiver as a pre-
amplifier
You can use the auto calibration function when
you use the receiver as a pre-amplifier.
In this case, the distance value shown on the
display may differ from the actual distance
value. However, there will be no problems
even if you continue to use the receiver with
that value.

Performing auto calibration

The auto calibration function allows you to
measure the following:
• Whether or not speakers are connected
• Polarity of speakers
• Distance of each speaker to your listening
b)
position
b)
• Speaker angle
b)
• Speaker size
• Speaker level
• Frequency characteristics
a) This receiver corrects signals by analog
downmix processing only for the center speaker
and sub woofer when MULTI IN is selected. The
correction is invalid for other speakers.
b) The measurement result is not utilized when
MULTI IN is selected.
c) • DTS 96/24 signals are always played back as
48 kHz when you correct signals.
• The measurement result is not utilized in the
following cases.
–MULTI IN is selected.
–"2ch Analog Direct" is being used (page 111).
–Input signals of which the sampling frequency
is more than 96 kHz are being received.
a)
c)
1
Choose Settings menu
(page 38).
The Settings menu list appears on the TV
screen.
2
Press V/v repeatedly to select
"Auto Calibration," then press
.
2-6
continued
43 GB