Assembly - HAMPTON BAY SUSSEX II AL694LED-BN Use And Care Manual

Assembly

1
Preparing the canopy
□
Remove the canopy ring (B) from the canopy (C).
□
Remove the two non-slotted canopy mounting screws
with lock washers (FF) from the canopy (C), and
loosen the slotted canopy mounting screws with lock
washers (FF) on the canopy (C).
□
Remove the canopy (C) from the mounting bracket (A)
by turning the canopy (C) counterclockwise.
FF
A
3
Assembling the fan
WARNING: Failure to properly install the cotter pin (GG)
could result in the fan loosening and possibly falling.
NOTE: If a longer downrod is needed (not included), take
out the screw located in the hanger ball, lower the hanger
ball and remove the pin. Remove all three pieces from the
downrod, and assemble them onto the new longer downrod
before proceeding to step 3.
□ Route the wires exiting from the top of the fan motor
assembly (F) through the coupling cover (E) and the
canopy ring (B). Ensure the slot openings are on top.
□
Route the wires through the canopy (C) and then
through the hanger ball / downrod assembly (D).
□
Align the holes at the bottom of the hanger ball /
downrod assembly (D) with the holes in the collar on
top of the fan motor assembly (F).
□
Carefully insert the clevis pin (HH) through the holes in
the collar and the hanger ball / downrod assembly (D).
Be careful not to jam the clevis pin (HH) against the
wiring inside the hanger ball / downrod assembly (D).
2
Preparing the motor
□
Remove the cotter pin (GG) and clevis pin (HH). Loosen
the two collar setscrews (II) from the motor collar.
FF
C
HH
B
□
Insert the cotter pin (GG) through the hole near the
end of the clevis pin (HH) until it snaps into the locked
position.
□
Tighten the two collar setscrews (II) on top of the fan
motor assembly (F) firmly.
8
II
II
HH
GG
II
F
D
C
B
E
GG
II
F