Eq Settings; Multi Zone Settings - Sony STR-DA5500ES Operating Instructions Manual

EQ settings

You can use following parameters to adjust the
tonal quality (bass/treble level) of front, center
and surround/surround back speakers.
Bass
Level
(dB)
Notes
• This function does not work in the following cases.
– The multi-channel input is selected.
– "2ch Analog Direct" is being used.
– Dolby TrueHD signals with a sampling
frequency of 176.4 kHz and higher are being
received.
• If the equalizer is adjusted while the receiver is
receiving signals with a sampling frequency of
176.4 kHz and higher, the signals will always be
played back at either 44.1 kHz or 48 kHz.
To adjust the equalizer on the
EQ screen
1
Press B/b to select the speaker on the
screen you want to adjust, then press
.
2
Press B/b to select "Bass" or "Treble."
3
Press V/v to adjust the gain, then press
.
136
GB
Treble
Frequency
(Hz)

Multi Zone settings

You can make settings for the main zone, zone
2 or zone 3.
Multi Zone Setup
To turn the power on or off for
zone 2/zone 3
You can turn zone 2 or zone 3 operation on or
off. "Main" (this receiver) is always selected.
You cannot turn it off.
1
Press V/v to select the zone you want
to turn on or off, then press
2
Press V/v to select "ON" or "OFF," then
press .
x ON
x OFF
To select the output source for
each zone
You can select the source that is output to the
zone. Audio and video signals are output to
zone 2, while only audio signals are output to
zone 3.
1
Press V/v to select the zone to which
you want to output audio/video signals,
then press .
2
Press B/b to select "Input," then press
.
3
Press V/v to select the input, then
press .
.