Table of Contents
Advertisement
9.
Installation
If the mattress system has come from
a storage / transport temperature
environment near to the minimum
or maximum values stated allow the
mattress and control unit to adjust
to room temperature for a minimum
of 2 hours prior to plugging into the
mains supply - Risk of electrical system
damage if operated outside of the
recommended temperatures.
Prior to installing and setting up the system
ensure the general warnings in section 8 have
been understood and actioned.
•
When specifying a mattress, bed frame and
side rail combination, a clinical assessment
of the patient's needs must be carried out in
line with local policy.
•
Once removed from the packaging, check
the product for any signs of damage. If
damaged do not put into use and contact
your distributer.
•
Remove all covers, sheets and the existing
mattress from the bed.
•
Position the mattress on top of the bed
frame, top cover facing upwards and feed
pipes at the foot of the bed for control unit
positioning.
•
Position the control unit by hanging the
hooks over the foot board. If there is no
foot board place the unit on the floor and
stand upright. Ensure the rear of the unit
is not obstructed by carpet, rugs etc. It is
advisable to place the unit on a firm surface.
14
|
Drive DeVilbiss Healthcare Ltd
|
Hybrid-Power
|
Instructions for use
Avoid placing the mattress system
in direct sunlight – Direct sunlight
could damage the mattress cover.
•
Attach the male and female feed pipes to
the control unit, ensuring the feed pipes do
not kink or become trapped between parts
of the bed frame.
•
Connect the mains plug to the nearest
source.
Do not route the mains cable through/
around mechanical bed assemblies;
it is recommended to use cable
management systems (where available),
or to position the cables so they run
along the floor under the bed, in a
position that will not cause a trip hazard
and/or damage to the cable. The
mattress system mains cable should not
be in tension when the bed is operated
through the range of travel available to
the user.
Ensure the control units mains lead
is positioned in such a way that there
is no risk of entrapment/trips or fall
hazards.
|
2021-01 rev7
Advertisement
Table of Contents
