Garage Smart Basic MyLifter Installation And Operation Manual page 12

7. Hold the mounting bracket in place on the ceiling and align the bracket's holes
with the pilot holes you drilled.
8. Use a 1/2 inch wrench or socket wrench to mount the bracket to the ceiling with
the included lag screws and washers.
9. Tighten the screws until the bracket is flush against the ceiling.
As you turn the wrench, you should feel resistance. If the lag screw turns
freely, your pilot hole is not in the ceiling stud. You will need to find the cen-
ter of the stud and drill new pilot holes.
if the lag screws are not screwed into the stud. Doing so may result in
property damage, serious personal injury, or death.
Do NOT
use an impact driver to insert the lag screws into the stud. The
impact could over tighten the screws causing them to fail, which may res-
ult in property damage, serious personal injury, or death.
10. Align the MyLifter unit with the mounting bracket and insert the included quick
release pins through the holes.
WARNING
Do NOT attempt to install the lifter