Adjusting The Rollers; Flow Restricor Tap; Blade Rotation - Major Verge Operator's Manual & Parts List

Adjusting the Rollers

• Slacken the Height adjuster stop lock nuts B and
• Adjust the roller adjuster A to obtain the desired cutting height.
• Tightly close the lock nut B again to keep the rollers in this position.
NOTE: IT IS IMPORTANT TO HAVE
ROLLERS LEVEL AFTER ADJUSTMENT.

Flow Restricor Tap

The speed of lowering and raising the machine is controlled by a Flow
Restrictor Tap which is located on the hydraulic hose connected to the Body
Ram. The adjustment should be carried out by a competent and qualifi ed
person.
In order to adjust the fl ow:
• Slacken grub screw A,
• Turn the knob B until desired speed lowering/raising is reached,
• Lock the position of knob B by tightening grub screw A.

Blade rotation

Blades must always be timed at 90 degrees to each
other as shown in diagram above. Failure to do so
can cause the blades to foul and in turn may damage
the transmission.
www.major-equipment.com
B
A
1400 Verge Major
2000 Verge Major
2650 Verge Major
A
B
9