Siemens SIMATIC RF166C Operating Instructions Manual page 79

Basic settings
In this area, you can use the "Reader interfaces" parameter to specify the reader for which a
firmware update is to be performed or which read point should undergo diagnostics.
Monitoring status
In this area you can update the reader and transponder parameters and reset error counters
of the reader.
Select the "Automatic cyclic update" check box to have the parameter values updated
automatically and cyclically.
Status
The following parameters are read and displayed:
Table 7- 13
Displayed parameters
Hardware type
Hardware version
Bootloader version
Firmware version
Driver type
Driver version
Interface
Transmission
speed
Distance limiting
Max. number of tran-
sponders
SIMATIC RF166C
Operating Instructions, 12/2019, C79000-G8976-C578-01
Displayed parameters of the "Reader status" area
Description
Hardware type of the reader
Hardware version of the reader
Bootloader version of the reader
Firmware version of the reader
Driver type of the serial interface of the reader
Driver version of the serial interface of the reader
Used serial interface of the reader
Possible values: RS232, RS422
Used transmission speed of the reader
Possible values: 19.2; 57.6; 115.2; 921.6 Kbaud
Set transmit power of the reader (RF380R)
The following values are possible:
Value
02
03
04
05
06
07
08
Maximum number of transponders to be expected that may be located in
the antenna field at the same time.
Meaning
0.5 W
0.75 W
1.0 W
1.25 W
1.5 W
1.75 W
2.0 W
Configuration using the WBM
7.3 The menu items of the WBM
79