Siemens SIMATIC RF166C Operating Instructions Manual page 143

AutoId OPC UA
status status
4 good
5 Bad
Invalid
Argument /
good
7 good
7 good
8 good
9 good
9 good
10 good
14 good
14 good
15 good
17 good
18 good
19 good
19 good
SIMATIC RF166C
Operating Instructions, 12/2019, C79000-G8976-C578-01
AutoId
text
PASSWORD_
ERROR
REGION_NOT_
FOUND_ERROR
OUT_OF_RANGE_
ERROR
OUT_OF_
RANGE_ERROR
NO_
IDENTIFIER
MULTIPLE_
IDENTIFIERS
MULTIPLE_
IDENTIFIERS
READ_
ERROR
WRITE_
ERROR
WRITE_
ERROR
NOT_SUPPORTED_
BY_DEVICE
DEVICE_NOT_
READY
INVALID_
CONFIGURATION
RF_COMMUNICATION_
ERROR
RF_COMMUNICATION_
ERROR
Error description
The transponder password is incorrect. Access is denied.
All commands:
A parameter of an OPC UA command has an invalid value.
"ReadTag"/"WriteTag" command:
The addressed memory area is not available in the current
transponder.
Address error
The address range of the transponder has been exceeded.
Possible causes:
Start address of the command start has been incorrectly
•
set.
Wrong transponder type
•
The area to be written to is write-protected.
•
The requested data is not available.
There is no transponder with the required EPC ID/UID in the
transmission window or there is no transponder at all in the
antenna field.
More transponders are located in the transmission window than
can be processed at the same time by the reader.
There is more than one transponder in the transmission win-
dow.
Read access to the transponder has failed.
Write access to the transponder has failed.
Writing the EPC ID/UID on the transponder has failed.
Unknown command
An uninterpretable XML command was sent to the reader or the
Ident profile sends an uninterpretable command to the reader.
Possible causes:
The "AdvancedCmd" block was supplied with an incorrect
•
"CMD".
The "CMD" input of the "AdvancedCmd" block was overwrit-
•
ten.
The specified read point is not active because no antenna was
assigned to it.
The specified tag field of the transponder is unknown.
The transponder is not responding.
The verification of the written transponder data has failed.
Service and maintenance
10.2 Error messages
143