Setting The Clock - Frigidaire GLEB30T9DS Control Manual

Setting the Clock

Setting the Clock
The CLOCK Clock pad is used to set the clock. The clock may be set for 12 or 24 hour time
of day operation. The clock has been preset at the factory for the 12 hour operation. When
the range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash with "PF" (power failure, See Figure 1).
When PF appears in the display, press
INSTRUCTIONS
To set the clock (example below for 1:30)
1. Press . "TIME" will appear in the display (Figure 2).
Clock
2. Press 1 3 0 pads to set the time of day to 1:30 (Figure 3).
"TIME" will stay in the display. Press
and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold Clock
"12Hr" (Figure 5) or "24Hr" (Figure 6) will appear in the display and
the control will beep once.
2. Press to switch between the 12 and 24 hour time of day
Clean
display. The display will show either "12Hr" (Figure 5) or "24Hr"
(Figure 6).
Clear
START
3. Press or
/Off
4. Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
Clear
A beep will sound and PF will disappear.
.
/Off
START
. "TIME" will disappear
for 7 seconds (Figure 3). After 7 seconds,
or wait 5 seconds to accept the change.
PRESS
Clock
1 3
0
START
Clock
for 7 seconds
Clean
Clear
START
or
/Off
2
Figure 1
DISPLAY
TIME
Figure 2
TIME
Figure 3
Figure 4
Figure 5
Figure 6