Setting the Clock
The do,_< pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation.
When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash along with "PF" (power failure, See Fig. 1).
When PF appears in the display and 12:00 is flashing, press
. No sound will be heard,
but after 10 seconds
a beep will sound and PF will disappear.
iNSTRUCTiONS
PR ESS
To set the clock
(example
below
for 1:30)
1.
Press
.... CLO" will appear in the display (Fig. 2).
<:lod<
_/oge"
2.
Press
3
pads to set the time of day to 1:30 (Fig. 3).
i
....
"CLO"
"CLO" will stay in the display. Press
will disappear
and the clock will start (Fig. 4).
Changing
between
12 or 24 hour time of day display
/
1.
Press and hold {Io_:k for 7 seconds (Fig. 3). After 7 seconds,
"12Hr" (Fig. 5) or "24Hr" (Fig. 6) will appear in the display and the
control will beep once.
2.
Press clean to switch between the 12 and 24 hour time of day display.
Nettoye[
The display will show either "12Nr" (Fig. 5) or "24Nr" (Fig. 6).
3.
Press #_PA_to accept the change or press _,,_,/oto reject the
change.
4.
Reset the correct time as described in To set the Clock above.
Please note that if the 24 hour time of day mode was chosen, the
clock will now display time from 0:00 through 23:59 hours.
_lo<i_for 7 seconds
Fig. 1
DISPLAY
Fig. 2
Fig. 3
Fig. 4
cieaii
Nettoyer
Fig. 5
_,_/0
OF
A_{,
........
Fig. 6
Setting
Temperature
Display = Fahrenheit
or Celsius:
_i::
andCLEAN
Clean ads
The BROIL
Nett0ye[
P
control the Fahrenheit or Celsius temperature display modes. The oven control
can be programmed to display temperatures
in Fahrenheit or Celsius. The oven has been preset at the factory to display
in Fahrenheit.
INSTRUCTIONS
PR ESS
DISPLAY
To change
display
from
Fahrenheit
to Celsius
or
Celsius
to Fahrenheit
(Fig.
1.
To tell if the display is set for Fahrenheit or Celsius press
7) and hold for 7 seconds; "550°``will appear and "BROIL" will flash in
the display and a beep will sound. If "F" appears, the display is set to
show temperatures in Fahrenheit (Fig. 8). If "C" appears, the display
is set to show temperatures in Celsius (Fig. 9).
Clean
2.
Press
Nett0yer
to switch between Fahrenheit or Celsius display
modes. The display will show either "F" (Fig. 8) or "C" (Fig. 9).
3.
Press _PART; IO accept the change or press
to reject the
change.
for 7 seconds
Fig. 7
Clean
Fig. 8
Nett0yer
Need help?
Do you have a question about the PGLEF385EC8 Guide and is the answer not in the manual?