Setting the Clock
Bake or 12 Hour Energy
The TIMER ONIOFF
o,,io, and CLEAN :Clean
pads control the Continuous Bake or 12 Hour Energy Saving features.
The oven control has a factory preset built-in 12 Hour Energy Saving feature that will shut off the oven if the oven
control is left on for more than 11 hours and 59 minutes. The oven can be programmed to override this feature for
To set the control
Bake or 12 Hour
Press and hold °n/°ff_ for 7 seconds (Figure1). After 7 seconds
"12h" or % -h" will appear in the display and the control will
to switch between the 12 Hour Energy Saving and
continuous bake features. Note: "12h" (Figure 2) in the display
indicates the control is set for the 12 Hour Energy Saving
mode and "- -h" indicates the control is set for the Continuous
Bake feature (Figure 3).
to accept the change (Figure 4; display will return
to time of day) or press d_,_/of_
A,_,,,ler' to reject the change.
On/Off for 7
The TIMER ON/OFF on/off pad controls the Timer feature. The Timer serves as an extra timer in the kitchen that will
beep when the set time has run out. It does not start or stop cooking. The Timer feature can be used during any of the
other oven control functions. Refer to "Minimum and Maximum Control Pad Settings" for time amount settings.
To set the Timer (example
for 5 minutes)
will appear and "TIMER" will flash in the
display (Figure 5).
Press the number pads to set the desired time in the display
(example ( 5 ). Press
The time will begin to count down
with "5:00" and "TIMER" will stay in the display (Figure 6).
is not pressed the timer will return to the time of
day after 25 seconds.
When the set time has run out, "End" and "TIMER" will show in
the display (Figure 7). The clock will sound with 3 beeps every
5 seconds until on/off is pressed.
the set time has
Press o,,/off The display will return to the time of day.