Table of Contents
Advertisement
de
environmental Protection
7th
environmental Protection
Packaging / old device
Environmental Protection
)
Dispose of packaging in an environmentally
friendly manner.
This device is labeled in
accordance with the European
Directive 2012/19 / EC on waste
electrical and electronic
equipment (WEEE).
The guideline provides the
framework for the EU-wide return
and recycling of old devices.
Save energy and resources
If these guidelines are followed, the device
uses less electricity and water.
Use programs with low temperatures and
longer washing times and utilize the
maximum load capacity ~ Page 29.
The energy and water consumption is
■
the most efficient.
Use economical program settings.
When the program settings are
■
adjusted for a program, the
expected consumption is shown on
the display.
Dose the detergent according to the
degree of soiling of the laundry ~ Page
28.
A smaller amount of detergent is
■
sufficient for light to normal soiling.
Observe the dosage recommendation
of the detergent manufacturer.
12th
Reduce the washing temperature for
lightly and normally soiled laundry.
The device uses less energy at low
■
temperatures. For light to normal
soiling, temperatures lower than those
indicated on the care label are
sufficient.
We
nn then put the laundry in
If the tumble dryer is to be dried, set the
maximum spin speed.
Drier laundry shortens the duration of
■
the drying program and thus lowers
energy consumption. The higher the
spin speed, the lower the residual
moisture in the laundry. At the same
time, the volume of the spinning noise
increases.
Wash the laundry without prewash.
Washing with prewash extends the
■
duration of the program and increases
energy and water consumption.
The device is equipped with an automatic
volume control.
The automatic amount adjusts the
■
water consumption and the program
duration optimally to the type of textile
and the load.
power saving mode
If the device is not used for a long period of
time (approx. 5 minutes), it will
automatically switch to energy-saving
mode. Before the start of the program and
after the end of the program, the display
panel lighting goes out, ~ (indicator lamp
on the buttonA) flashes. To activate the
Touch the display backlight anywhere on
the display panel.
The energy-saving mode is not activated
while the program is running.
Advertisement
Table of Contents
