Table of Contents
Advertisement
de
Positioning and connecting
Incorrect laying of the hose and power
■
lines creates the risk of tripping and
injury. Lay hoses and lines so that there
is no risk of tripping.
Caution!
Equipment damage
Frozen hoses can tear / burst.
Do not set up the device in areas at risk of
frost and / or outdoors.
Caution!
Water damage
The connection points of the water inlet
and water outlet hose are under high
water pressure. In order to avoid leakage
or water damage, it is essential that you
follow the instructions in this chapter!
Hints
In addition to the information listed
■
here, special regulations of the
responsible water and electricity
company may apply. If in doubt, have
a specialist connect it.
■
Installation area
A notice:
The device must be aligned in a
stable manner so that it does not move.
The installation surface must be firm
■
and level.
Soft floors / floor coverings are
■
unsuitable.
14th
Installation on a base or
wooden floor
Caution!
Equipment damage
The device can wander during the spin
cycle and tip / fall from the base. The
device feet must be fastened with
retaining straps.
Order no. WMZ 2200, WX 975600, CZ
110600, Z 7080X0.
A notice:
In the case of wooden beam
ceilings, set up the device:
if possible in a corner,
■
on a water-resistant wooden board
■
(min. 30 mm thick) that is firmly
screwed to the floor.
Setting up the device in a
kitchenette
:
warning
Risk of death!
Contact with live parts creates the risk
of electric shock.
Do not remove the cover plate from the
device.
Hints
Niche width of 60 cm required.
■
Only set up the device under a
■
continuous worktop that is firmly
connected to the neighboring cabinets.
Advertisement
Table of Contents
