Table of Contents
Advertisement
0
Program preset
lungs
You can change the default settings of
Program presets
selected programs. The settings can also
be changed while the selected program is
running. The effects depend on the
progress of the program.
6th Temp. (Temperature)
Before and after the program start, the
temperature setting can be changed
depending on the progress of the
program by adjusting the desired speed
on the display.
The maximum temperature that can be set
depends on the selected program.
0 Spin
Before and during the program,
depending on the progress of the
program, you can change the spin speed
(in rpm, revolutions per minute) by
adjusting the desired speed on the display.
attitude 2: 2 = "No spin ". Without final
spin, the water is only pumped out. The
laundry remains wet in the drum, eg if
items of laundry should not be spun.
"No spinning" can be selected to avoid
creasing if the laundry is not removed
from the appliance immediately at the
end of the program.
The maximum speed that can be set
depends on the model and the selected
program.
Program preferences
ñ Finished in / Time Dry
Before the program starts can the pro
End of gram ("Finish in" time) in steps of
0.5 h (h = hour) (between "at least
selectable end time" and 9.5 h) or in steps
of whole hours (between 10 h and 24 h)
can be preselected up to a maximum of 24
hours.
In addition:
1.
Select a program (with the exception of
the program ‰ My time
Dry (time program drying). *
The program duration for the selected
program, e. B.2:30 (Hours: minutes) is
displayed.
2.
The key ñ Finished in / Time Dry
Press repeatedly until the required
number of hours is displayed.
3.
The key A.Start / Reload (start /
reload) to choose.
The program starts.
The selected number of hours
z. B.8 h, is shown in the display and
counts down until the program
begins. The program duration is then
displayed.
A notice:
The program duration is
automatically adjusted while the program
is running. Changes to the program
default settings or additional program
settings also result in changes to the
program duration.
After the program start (when a
"Finish in" time has been selected and the
program has not yet been started) the
preselected number of hours can be
changed as follows:
1.
The key A.Start / Reload (start /
reload) to choose.
2.
The key ñ Finished in / Time Dry
Press repeatedly to change the number
of hours.
3.
The key A.Start / Reload (start /
reload) to choose.
*
Depending on the model
de
35
Advertisement
Table of Contents
