Information On The Display Panel - Bosch WNA13400EU Instructions For Use And Installation

Washer dryer
Table of Contents

Advertisement

de
Malfunctions and remedial measures
Notes on the display panel
advertisement
O
• © £ (hot)
r
E. shines
The symbol Û
flashes.
E: 36
alternating with
- 10
E: 35
alternating with
- 10 (suitable for
special models)
48
Cause / remedy
Flashes quickly + beep: The washing machine door was opened when the water level
was too high. Close the washing machine door and the program with the buttonA.
Start / Reload (start / reload) continue or [Drain to choose.
Flashes slowly: The window locking temperature is too high to open
the loading door. Wait about 30 seconds for the window lock to cool
down.
The temperature in the drum is too high. Let the appliance run and wait until
the laundry has cooled down enough that• © £ (hot) is no longer displayed.
The washing machine door can then be opened.
Flashes (no water supply): Is the tap turned on? Is the filter in the
water inlet blocked? ~ " Clogged water inlet filter "on page 46
Is the inlet hose kinked or pinched?
Shines (low water pressure): For information only. This has no effect on
the progress of the program. The program duration is extended.
The child lock is activated. Please deactivate.
The program Cottons (cotton) i 90 ° C to clean and care for the
drum and the tub.
Hints
Run the program without laundry.
Use powder detergent or a detergent containing bleach. To avoid
foam formation, only use half the amount of detergent recommended
by the detergent manufacturer. Do not use wool or mild detergents.
Switch the drum care information signal on / off. ~ Page 42
Clogged drain pipe or water drainage hose. Clean the drain pipe
and water drain hose.
The drainage pipe or the water drainage hose is kinked or
trapped. Make sure that the drainage pipe and the water
drainage hose are not kinked or pinched.
The drain pump is blocked.
~ " The drain pump is blocked "on page 44
The drain hose on the siphon is blocked.
~ " The drain hose at the siphon is blocked "on page 45
The water drainage hose is connected too high. Install the water
drainage hose at a maximum height of 1 meter.
~ Page 16
There is water in the floor pan. The device is leaking. Close the
water tap. Call customer service.

Advertisement

Table of Contents
loading

Table of Contents