Regent Lighting Solutions Bilux Inground Installation Instructions

Bilux Inground
ALL CONNECTIONS TO BE CARRIED OUT BY A QUALIFIED ELECTRICIAN
PLEASE READ CAREFULLY BEFORE STARTING INSTALLATION.
Remote Electronic Control Device
Bilux Inground
Save These Instructions for Future Reference
Electrical products can cause death, injury, or damage to property.
Installation of this product must be carried out by a qualified electrician,
in compliance with SANS 10142 or corresponding regulations of the
country of installation. On completion of installation, the Certificate of
Compliance must be updated.
For non user replaceable light source: The light source contained in this luminaire
shall only be replacedby the manufacturer or his/her service
agent or a similar qualied person
WARNING: TO AVOID FIRE, SHOCK OR DEATH
TURN OFF POWER AT CIRCUIT BREAKER OR FUSE AND TEST THAT THE POWER IS OFF BEFORE WIRING
ALL LUMINAIRES SUPPLIED AND TO BE INSTALLED ABOVE AND BELOW 5 METERS ARE IN COMPLIANCE WITH
SANS 60598 SECTION 3.5.6 ACCORDING TO THE MANUFACTURER GUARANTEE AND WARRANTY
Regent Lighting reserves the right to change specifications modify designs and discontinue items
without incurring obligation and whilst every effort is made to ensure that descriptions, specifications
and other information in this catalogue are correct, no warranty is given in respect thereof and the
company shall not be liable for any error therein.
www.regentlight.co.za
REGENT LIGHTING A DIVISION
OF WAHL INDUSTRIES.
September 2021
www.regentlight.co.za
WARNING
ELECTRIC SHOCK
HAZARD
This equipment is to be
serviced by trained
personnel only.
3 - 13 MAIN REEF SERVICE ROAD, CORNER
SPRINGBOK AND MAIN REEF ROAD, INDUSTRIA,
JOHANNESBURG. SOUTH AFRICA.
TEL : +27 11 474 0171
INSTALLATION INSTRUCTIONS
PLEASE READ CAREFULLY BEFORE STARTING INSTALLATION.
ALL CONNECTIONS TO BE CARRIED OUT BY A QUALIFIED ELECTRICIAN
Remote Electronic Control Device
DO NOT CONNECT THE LUMINAIRE LIVE
1
1 98
1
53
DO NOT PLUG 145mm
(CONNECT) WHEN
Hole depth
LIVE AS IT WILL CAUSE
DAMAGE TO THE
LUMINAIRE.
1. Selected the required position for the luminaire.
Create cavity in for plastic sleeve.
2
2
2
GROUND
13/19mm Chip
Stones
PAVING/
CEMENT
DRAIN
Bilux Inground
WARNING
ELECTRIC SHOCK
HAZARD
This equipment is to be
serviced by trained
personnel only.
Be sure the electricity to the system
Ÿ
you are working on is isolated.
If the main supply power (live) is on,
Ÿ
it will cause damage to the
luminaire.
Ÿ
Control gear weight: 220V - 240 V
AC 50 Hertz
Ÿ Ambient temperature: Ta 36ºC
IP rating according to IEC 60598-1:
Ÿ
-Optical compartment: IP65
-Gear compartment: IP65
Mounting: In-ground installation
Ÿ
2. Create a cavity for tting in the
ground/paving at the required position.
NB: GRAVEL FOR DRAINAGE: Lay at least
50mm of 13mm or 19mm Chip Stones
beneath the well of the cavity and
check drainage efciency.
Drainage detail spec by Civil
Engineer.
Ensure there is a drain under the
substrate when installing the tting into
paving or cement
www.regentlight.co.za