Bevel Gear Case And Axle Case - Toro Reelmaster 6500-D Service Manual

Bevel Gear Case and Axle Case

The following procedures assume the rear axle assem-
bly has been removed from the machine.
Removal
1. Remove the mounting screws, nuts, and lock wash-
ers. Remove the bevel gear case/axle case assembly
and O-ring from the axle support (Fig. 17).
2. Mark both right and left bevel gear case/axle case
assemblies.
IMPORTANT: Do not interchange right and left
bevel gear case/axle case assemblies.
3. Remove the axle cover mounting screws. Remove
the axle cover from the axle case as an assembly
(Fig. 18).
4. Remove the axle case support mounting screws, the
axle case support, and the support shims (Fig. 19).
Axles, Planetaries and Brakes (Rev. C)
4
35 to 41 ft- -lb
(47 to 56 N- -m)
1. Cap screw
2. Lock nut
3. Lock washer
4. Axle support
1. Axle case
2. Axle cover assembly
2
1. Axle case
2. Axle case support
Page 6 - 16
1
6
2
3
Figure 17
5. Bevel gear case/axle
case assembly
6. O-ring
17 to 20 ft- -lb
(23 to 27 N- -m)
1
4
2
Figure 18
3. Mounting screw
4. O-ring
3
57 to 67 ft- -lb
(77 to 91 N- -m)
4
Figure 19
3. Mounting screw
4. Support shim
Reelmaster 6500-D/6700-D
35 to 41 ft- -lb
(47 to 56 N- -m)
5
3
1