Assign Section; The Synth Presets - Viscount SYNTH-8 User Manual

Parameter editing

ASSIGN section

The Assign section allows you to assign any of the Synth-8
module generation parameters to the four controls
[ASSIGN 1], [ASSIGN 2], [ASSIGN 3] and [ASSIGN 4].
As seen on page
parameters based on the selection of the row of the table
printed on the panel. However, if no row in the table is
selected, the 4 adjustment knobs will control the assigned
parameters, thus ensuring convenient and quick access to
the most useful parameters for each Program.
To access this menu, in the EDIT SYNTH-8 screen (page 6), place the cursor on the LFO 1
or LFO 2 field and press the data entry dial.
Parameter name Description
Assign 1 Assigning the parameter to the knob [ASSIGN 1]
Values: all the parameters present in the SYNTH-8 menus.
Assign 2
Assigning the parameter to the knob [ASSIGN 2]
Values: all the parameters present in the SYNTH-8 menus.
Assign 3 Assigning the parameter to the knob [ASSIGN 3]
Values: all the parameters present in the SYNTH-8 menus.
Assign 4 Assigning the parameter to the knob [ASSIGN 4]
Values: all the parameters present in the SYNTH-8 menus.

The Synth Presets

Synth-8 provides 128 preset sounds to be used
immediately or from which to start your own programming
and configuration of a sound. When storing the Program, it
will contain the parameters of the selected or modified
Preset, although, when viewing the SYNTH-8 PRESETS
screen, it will always show the last Preset selected,
regardless of the one present at the time of storing the
Program.
To access the Synth Preset library, hold down the [▼] / [PRESETS] button for a while; the
screen shown on the side will be displayed. To select the Preset use the dial data entry: by
playing on the keyboard it will be possible to listen to the selected Preset. To confirm the
selection, press the dial data entry or the [▼] / [PRESETS] button. To cancel the selection,
press [EXIT].
Synth-8 – User Manual
6 in fact, these knobs adjust the
EN
- 18