Viscount SYNTH-8 User Manual page 19

Step Sequencer mode, capable of playing back sequences of notes and controls by pressing
a key on the keyboard. The sequence will start with the note pressed to continue with the
preprogrammed pattern. The Step Sequencer mode provides 40 preprogrammed patterns
and 8 user-programmable patterns, which can be edited using the Legend '70s Editor
application.
To access this menu, in the EDIT SYNTH-8 screen (page 6), place the cursor on the LFO 1
or LFO 2 field and press the data entry dial.
NB
The table below shows all the parameters available for the ARP section. The knob or button that
allows direct control from the panel is shown under the name of the parameter.
Parameter name Description
Arp Switch Activation / deactivation of the Arpeggiator or Step Sequencer function.
[ASSIGN 1] Values: OFF, ON
Arp Tempo Arpeggio or sequence playback time.
[ASSIGN 2] Values: between 40 and 148x8 bpm
Arp Hold Activation / deactivation of the Hold function that allows you to keep the
[ASSIGN 3] playback of the arpeggiated notes or the sequence even by releasing the keys.
The subsequent notes played will replace the previous ones in the arpeggio
phase or will start the sequence starting from the new note.
Values: OFF, ON
Arp Mode Values:
 Up: arpeggio from the lowest to the highest note.
[ASSIGN 4]
 Down: arpeggio from the highest to the lowest note.
 Up+Down: arpeggio from the lowest note to the highest and then return to
 Random: random arpeggio.
 Up 2: like Up but on two octaves.
 Down 2: like Down but on two octaves.
 Up+Down 2: like Up+Down but on two octaves.
 Random 2: like Random but on two octaves.
 Up 3: like Up but on three octaves.
 Down 3: like Down but on three octaves.
 Up+Down 3: like Up+Down but on three octaves.
 Random 3: like Random but on three octaves.
 Step Seq 1...50: selection of the pre-programmed sequences of the Step
 User Seq1...8: selection of the sequences programmed by the user of the
Arp Restart When activated (ON) each new note played on the keyboard restarts the
arpeggio or sequence from the beginning. If it is deactivated (OFF) the
sequence will continue from the point in which it is when the new note is
pressed.
Values: OFF, ON
the lowest note.
Sequencer. The Step Sequencer allows you to play sequences of notes
starting from the one played according to a pre-programmed rhythmic pattern,
with the continuous modification of some controls (filter frequency, oscillator
level, modulation change, etc.).
Step Sequencer. Programming of the 8 sequences can be done using the
Legend '70s Editor application.
EN - 17
Parameter editing
Synth-8 – User Manual