Lfo 1 And Lfo 2 Sections - Viscount SYNTH-8 User Manual

Parameter editing
Mod Pitch Dest

LFO 1 and LFO 2 sections

Synth-8 allows you to adjust many parameters such as the frequency of the modulating
signal, to choose its waveform, to adjust the modulation depth, to establish synchronization
with the instrument's master clock and more. The SYNTH LFO 1 and SYNTH LFO 2 menus
contain the adjustment parameters for the first and second LFOs respectively. These
parameters are common for both oscillators and are described in common in the table below.
To access this menu, in the EDIT SYNTH-8 screen (page 6), place the cursor on the LFO 1
or LFO 2 field and press the data entry dial.
NB
The table below shows all the parameters available for the LFO 1 and LFO 2 sections. The knob
or button that allows direct control from the panel is shown under the name of the parameter.
Parameter name
LFO1 Shape
LFO2 Shape
[ASSIGN 1]
LFO1 Rate
LFO2 Rate
[ASSIGN 2]
LFO1 Amount
LFO2 Amount
[ASSIGN 3]
Synth-8 – User Manual
Selection of the oscillator whose pitch must be controlled by the envelope.
Values:
 Osc1+2 Pitch: the envelope controls the pitch of both oscillators.
 Osc1 Pitch: the envelope controls the pitch of oscillator 1 only.
 Osc2 Pitch: the envelope controls the pitch of oscillator 2 only. This is
particularly useful to dynamically change the timbre of Osc2 when the
Osc2 Sync mode is active.
Description
Waveform selection.
Values:
 OFF: no waveform generated (LFO disabled).
 Triangle: triangular waveform.
 Sine: sine waveform.
 Sawtooth: sawtooth waveform.
 Rev Saw: inverted sawtooth waveform.
 Square: square waveform.
 Vintage Sine: variant of the Sine with more squared half-
wave peaks.
 Parabola: waveform obtained from parabolic sections.
 Random: waveform with a sequence of slightly filtered
random values.
 Step Random: waveform with a sequence of random values.
Frequency of the signal generated by the LFO (modulation frequency applied
to the destination, see LFO1 Dest or LFO2 Dest parameter).
Values: between 0 and 127
Level of the signal generated by the LFO (modulation depth applied to the
destination, see LFO1 Dest or LFO2 Dest parameter).
Values: between 0 and 127
EN
- 14